A Step-by-Step Guide to Replacing Your Old Water Heater

admin
0
on Nov 20, 2024

Is your water heater on its last legs? Are you tired of lukewarm showers and high energy bills? It may be time to replace your old water heater with a new, more efficient model. Replacing a water heater may seem like a daunting task, but with the right tools and know-how, you can tackle this project yourself and save money on installation costs.

Step 1: Turn off the power and water supply Before you begin any work on your water heater, make sure to turn off the power supply at the breaker box. You should also shut off the water supply to the tank by turning the valve located near the top of the unit.

Step 2: Drain the tank Next, connect a garden hose to the drain valve at the bottom of the tank and run it outside or into a floor Code 3 Plumbing and Drain allow all of the hot water in the tank to drain out completely.

Step 3: Disconnect pipes Once all of the water has drained from the tank, disconnect both cold and hot-water pipes from their respective connections on top of the unit using a pipe wrench. Be sure to have a bucket handy to catch any remaining water in these pipes.

Step 4: Remove old unit With all connections disconnected, carefully remove your old water heater from its location. This may require two people as these units can be heavy. Be sure to follow proper safety precautions when lifting and moving this appliance.

Step 5: Install new unit Carefully place your new water heater in position where your old one was located. Make sure it is level before reconnecting pipes using Teflon tape or pipe joint compound for secure seals.

Step 6: Fill tank with water Open up one of your hot-water faucets in your home before turning on both cold-water supply valves leading into your new unit.

In conclusion, replacing an old water heater is not as difficult as it may seem if you follow these steps carefully.

Code 3 Plumbing and Drain
7417 NW 84th St, Oklahoma City, OK 73132
405-860-6888